Guangzhou Zhenroumei Chemical Coatings Limited

GOODSIF Series Product Name/Model：MF2K Solid Colors Characteristic：MF2K Solid Colors, high gloss and build, good performance of leveling property,easy construction, excellent pretective and coveraging power, long lasting bright color. Mainly applies to intermediate cars, MPV and bus. Substrates Well-Sanded, Completely dried and good existing finishes as bellow: A original paint     B. Old paint firm     C. 1K or 2k primer Surface Cleaning Wash by warm soap, remove wax, silicon and other contaminations with degreaser, sanding with P800-P1000, wash with clean water then keep dry; again with degreaser. Mixing Ratio MF2K Solid Colors Hardener Thinner 2 1 0.2-0.4 ＜15℃ MF2K Solid Colors MF281 Fast Hardener  60 Fast Thinner 15-30℃ MF2K Solid Colors MF282 Standard Hardener 61 Standard Thinner ＞30℃ MF2K Solid Colors MF283 Slow Hardener 62 Slow Thinner Spray Viscosity 16-19s to drop off, in 4# viscosity cup, at 25°C, Pot-life At 25°C 2 hours with fast hardener. 4 hours with standard or slow hardener. Re-Treatment There are particles or runs after spray, sand affected area with P2000 sand paper after thorough drying, then polish to solve the problem. Spray Gun Set Up Gravity Feed: 1.2-1.5mm 3-5kg/cm ² Suction Feed: 1.4-1.6mm 3-5kg/cm² Spray Technology Coats&Thickness: 2-3 coats, total 35-50um Flash-Off Time: At 25°C, 5-10 minutes between two coats, Air-Drying Time: Allow 10-15 minutes air drying time before force drying Temperature Dust Free  Tack Free Dry To Handle Dry To Test +25°C  40 minutes   2 hours  9 hours  6 Days +70°C 5 minutes 10 minutes  25 minutes  50 Minutes Shelf Life 2 years in original sealed can, cool and dry place at 25℃. Package 1L×12 or 3.75L×4 Note: 1. The substrate must be cleaned and sanded before spray, wet sanding P800-1000 and then dry. 2. At ambient temperature higher than 30℃, add appropriate Retarder Solvent into thinner to avoid blushing. For more details, please refer to technical data sheet of Retarder Solvent. 3. The products mixed with hardener should be used up soon and can not be restore for future use;clean equipments immediately with thinner after application, otherwise it is very difficult to be cleaned after dry.